• 802.11 b/g/n
• Wi-Fi Direct (P2P), soft-AP
• Integrated TCP/IP protocol stack
• Integrated TR switch, balun, LNA, power amplifier and matching network
• Integrated PLLs, regulators, DCXO and power management units
• +19.5dBm output power in 802.11b mode
• Power down leakage current of <10uA
• 512kB/1MB Flash Memory
• Integrated low power 32-bit CPU could be used as application processor
• SDIO 1.1 / 2.0, SPI, UART
• STBC, 1×1 MIMO, 2×1 MIMO
• A-MPDU & A-MSDU aggregation & 0.4ms guard interval
• Wake up and transmit packets in < 2ms
• Standby power consumption of < 1.0mW (DTIM3)

5PCS AMS1117-3.3 3.3V DC-DC Step-Down Power Module Buck Module LDO 800MA

EUR 1.--

Features:
Size:8.6mm x 12.33mm
Input voltage: DC 4.2 V-10 V
Output: 3.3 V, 800 mA

Description: 
1.Boost modules or buck module indicate the operating voltage, Please donot exceed operating voltage , or it will be damaged easily. 
2.Boost module output voltage can only be greater than or equal to input voltage, cannot be less than the input voltage. 
3.Buck module input voltage must be higher than output voltage of 1.5V or 2V, otherwise it can not output enough power. 
4.Automatic Adjustable Boost or Buck module has start voltage and limit working voltage, Please donot exceed them , or it will be damaged easily. 
5.Cannot reverse polarity , or it will be short circuit, or will be  born easily. 

Connection:

UART        Adapter
3.3V           VCC
3.3V           CH-PD
TX               RX
RX              TX
Choose both NL CR 15200 baud rate

Package Included:

• 1 X ESP-01 Breakout Board Breadboard Adapter
• 2 X 4P male header

• 1 × pcs

Type:AM2302
Accuracy resolution:0.1
Humidity range:0-100%RH
Temperature range:-40~80?
Humidity measurement precision:±2%RH
Temperature measurement precision:±0.5?
ultra-low power
No additional components
excellent long-term stability
All calibration, digital output
completely interchangeable
long distance signal transmission
relative humidity and temperature measurement.

Description

The INA3221 is a three-channel, high-side current and bus voltage monitor with an I2C- and SMBUS-compatible interface. The INA3221 monitors both shunt voltage drops and bus supply voltages, in addition to having programmable conversion times and averaging modes for these signals. The INA3221 offers both critical and warning alerts to detect multiple programmable out-of-range conditions for each channel.
The INA3221 senses current on buses that can vary from 0 V to 26 V. The device is powered from a single 2.7-V to 5.5-V supply, and draws 350 µA (typ) of supply current. The INA3221 is specified over the operating temperature range of –40°C to +125°C. The I2C- and SMBUS-compatible interface features four programmable addresses.

Features

• Senses Bus Voltages From 0 V to 26 V
• Reports Shunt and Bus Voltage
• High Accuracy:
  • Offset Voltage: ±80 µV (max)
  • Gain Error: 0.25% (max)
• Configurable Averaging Options
• Four Programmable Addresses
• Programmable Alert and Warning Outputs
• Power-Supply Operation: 2.7 V to 5.5 V

Technische Daten

Produktname: Shunt Widerstand
Material: Metall
Modell: FC-1
Farbe: Gold Ton
Strom: 400A
Spannungsabfall: 75mV
Dimension: 64 x 25 x 13mm / 2.52" x 0.98" x 0.51"(L*W*T)
Nettogewicht: 117g
Lieferumfang: 1 x Shunt Widerstand

Beschreibung:

• FC-1, Typ, bewertet 400A, Strom, Spannung 75mV bewertet, gold Ton Metall Material.
• Der Splitter kann den hohen Strom direkt übergeben.
• Messbereich von Amperemeter aufwenden kann verwendet werden. DC-Amperemeter und Splitter werden zusammen verwendet.
• Gute Qualität, gute Leistung und einfache Installation.

Beschreibung

Der Shunt-Widerstand ist ein Gerät, das dem DC-Amperemeter zur Messung von hohem Strom helfen kann. Technisch muss ein Shunt parallel zum Amperemeter geschaltet werden (Stromteilung in Parallelschaltung)
Der Shunt-Widerstand hilft dem Strommesser, den Großteil des Stroms zu umgehen. Basierend auf dem Prinzip des Ohmschen Gesetzes könnte der Strom durch ein DC-Amperemeter berechnet werden, wenn ein Shunt die Spannung absenkt.Wenn es irgendwelche Herausforderungen gab, könnten Sie verwirrt werden. (Z. B. Schaltplan) Unser technisches Support-Team würde sich freuen, Sie zu unterstützen.

Feature:

• Nennstrom: 400A
• Spannungsabfall: 75 mV
• Gewicht: 234g / 8.3oz
• Länge: 125 mm / 4,9 Zoll
• Modell: FL-2
• Genauigkeit: 0,5
• Country of Manufacture CHINA
• Material Plastic,Metal
• Net Weight 234g
• Package Content 1 x Shunt Resistor
• Model FL-2
• Style 400A